static routing

static routing

You are working as a networking specialist at a company called “IT Hepdesk”. One of their customers has
2 dedicated links to connect their New York site to the Washington site. You are not allowed to use
routing protocols because they are paying for every single bit that’s sent on these links. You need to do
use static routing to get the job done and keep the customer happy.
Tasks:
•
There is a Loopback0 interface on the Washington router: IP Address 6.6.6.630.
•
There is a Loopback0 interface on the New York router: IP Address 3.3.3.3/30.
•
New York: create a static route pointing to the Loopback0 network on Washington, traffic should
pass the 192.160.1.0 network.
•
Washington: create a default route pointing to the Loopback0 network on New York, traffic should
pass the 192.160.2.0 network. In the routing table you should see a 0.0.0.0 entry.
•
New York: create a backup static route pointing to the Loopback0 network on Washington,
administrative distance should be 100.
•
Washington: change the default route so it stays in the routing table even when the interface goes
down.
you can use different IP configuration while doing the Tasks but make sure to explain why your using this
IP configuration for your network and explain all the commands that you are using in the GNS3 as much
as possible.
make sure to explain your GNS3 appliances selection(router/switch/hub/PC)
make sure to cite your references and screenshort should have date and timestamps if not your
assignment will not be accepted